Step 1: Attach approximately 25ft of Wire to the two leads on the palm tree light (#16 low voltage wire)
Step 2: Attach wire between screws to create a hanger
Step 3: Determine installation mounting height approxi-mately 15 to 20 feet above ground. Install drywall screw in palm tree, this will be used tem-porally to hold wire hanger in place. ( make sure the X on bubble sensors are facing towards ground)
Step 4: Install adjustable stainless steel band to light and wrap around tree, Tight-en to hold in place on tree.
Step 5: Run wiring down the back side of tree, stapling the wire approximately eve-ry 8 to 10 feet to the bottom of the tree.
Step 6: Run wire from bottom of tree to low voltage LED 12 volt transformer, Press desired color or function on remote installation is complete.